In this configuration, the shutdown command appears under all interfaces, which indicates all interfaces are currently shut down. The show running-config command shows the configuration of the router. These commands erase your startup configuration. Warning: Do not enter copy running-config startup-config or write. Type configure memory or copy startup-config running-config in order to copy the nonvolatile RAM (NVRAM) into memory. You are in enable mode and you see the Router# prompt. Type no after each setup question, or press Ctrl-C in order to skip the initial setup procedure. The router reboots, but ignores the saved configuration. This step bypasses the startup configuration where the passwords are stored. Type confreg 0x2142 at the rommon 1> prompt in order to boot from Flash. Once the router is on Rommon mode, reinsert the compact flash. This image shows the rear of the 2951 router:įor more information, refer to Overview of the Routers. Remove the compact flash that is on the rear of the router. Step-by-Step ProcedureĮither switch off or shut down the router. Use the procedure described in this document in order to replace the enable secret password. The enable password password can be recovered, but the enable secret password is encrypted and must be replaced with a new password. These passwords protect access to privileged EXEC and configuration modes. This document describes how to recover the enable password and the enable secret passwords. Refer to Cisco Technical Tips Conventions for more information on document conventions. Refer to Password Recovery Procedures for information on how to recover passwords for related products. If your network is live, ensure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. The information in this document is based on these hardware versions:Ĭisco 2900 Series Integrated Services Router (ISR) There are no specific requirements for this document. This document describes how to recover the enable password and the enable secret passwords for the 2900 Cisco Router.
0 Comments
Leave a Reply. |